Used 1983 Jeep CJ-7 for sale in Martinsburg, WV
$14,000
Vehicle Details
1983 Year | $14,000 Price | other Body Type |
good General Condition | clean Title Status | 8 cylinders Cylinders |
manual Transmission | 4wd Drive Train | gas Fuel Type |
Vehicle Description
-AMC 360 professionally built, bored to 366 cu in. Full valve job, 9.5:1 compression with Edelbrock cam, Air gap manifold and 670 cfm Holley truck avenger carb.
-T-18 4 speed trans with 6.32:1 first gear which has been rebuilt with new gears, synchros and bearings
-Dana 300 with JB Low-max 4:1 gear set.
-High Angle Driveline 1 ton CV rear driveshaft (1350 joints)
-Dana 44 front axle from a Wagoneer and shortened to Jeep wide track width. 4:10 gears with Eaton E-locker and CRv shafts.
-Ford 9 inch HD rear axle(big bearing, HD housing, 11x2.5 drum brakes) shortened to wide track width. With HP center section, 31 spline CRv shafts and Detroit Tru-Trac.
-Other goodies include, MSD 6al ignition, MSD distributor and wires, On-board air compressor system(belt driven from motor), 8000 lbs Mile Marker winch.
I just keep thinking of more and more stuff this Jeep has and it’s impossible to list it all. If you are seriously interested, come take a ride in it, but please don’t waste my time. I don’t need to sell it but I’d like to see someone enjoy it as much as I used to.
Calls only to 304-671-56 three four. Please don’t call after 9:30pm