Used 2003 Mitsubishi Lancer Evolution for sale in Higley, AZ
$22,000
Vehicle Details
2003 Year | 130,000 mi. Mileage | $22,000 Price |
sedan Body Type | mid-size Size | black Exterior Color |
good General Condition | clean Title Status | 4 cylinders Cylinders |
manual Transmission | 4wd Drive Train | gas Fuel Type |
Vehicle Description
Perfect project Evo with freshly built long block and many premium parts. Ready to make over 800WHP including a brand new Sheepey Race turbo kit. After 8 years of ownership it is finally time to let go. Unfortunately do not have the space or time so the car needs a new home.
The car is currently apart and does not run at as it is currently in need of the following parts listed below. The car is a clean title car with zero rust. I purchased this car in 2014 from southern California where it was originally owned. Since purchasing this car it has been garage kept and run very little ( a total of 4000 miles during my ownership ). In 2016 the engine was completely rebuilt featuring a 2.3 stroker and built/ported head. Since the rebuild the engine was run for roughly 1000 miles on a stock EVO 9 turbo before the car was taken down for the Sheepey components. The car does not include A/C components as they will not function with this forward facing turbo kit.
Good: Zero rust, clean interior ( aside from typical blue Recaro driver seat ), perfect dash , clean engine bay, no damage to core support or any major body components
Bad: Paint is in rough shape as clear coat is peeling on hood and roof. Various stratches around exterior, no major dents or damage just several average to light door dings. A vinyl wrap or paint would bring it back to life.
Engine 2.3 Stroker ( roughly 1000 miles at 420whp ) :
- Wiesco 1400HD Pistons 85.5mm 10.5:1
- Oliver Extreme Turbo Rods 150mm
- OEM 100mm crank shaft
- ARP Main Studs
- ARP L19 head studs
- ACL race bearing set
- All new OEM gaskets and seals everywhere
- New OEM oil pump & water pump
- New OEM EVO 9 timing belt with OEM pulleys and tensioner
- BSW street port and polished head
- GSC intake/exhaust valve set ( standard size )
- GSC Hi rev Beehive springs w/ titanium retainers
- GSC billet R2 Stroker cams 274
- Stock ported intake manifold
Transmission:
- All new gear sets including Evo 9 first gear
- Evo 9 carbon synchro's
- BSW custom shim spec
- All new seals and full refresh including paint
Installed aftermarket parts:
- ACT sprung 6 puck clutch w/ HD pressure plate
- Walbro 255 fuel pump
- Tein lowering springs ( stock struts )
- Torque Solutions short shifter w/ bushings
- Cobb shift knob
- Rexpeed carbon arm rest
- Rexpeed carbon gauge cluster trim
- Rexpeed carbon handbrake handle
- AEM wideband AFR gauge ( Digital )
- New OEM Evo 8 floor mats
Uninstalled Aftermarket parts:
- ( NEW ) Sheepey Race forward facing V-Band hot parts kit ( including teardrop hood dump down pipe and wastegate dump, full down pipe for optional catback use and 3 inch aluminum intercooler piping with couplers and T-Bolt clamps
- ( NEW ) Gen 2 Precision Turbo 6466 .82 V-Band
- Sheepey Race AN turbo feed and return lines ( with DEI heat shielding )
- ( NEW ) TurboSmart Race port 50mm BOV
- ( NEW ) TurboSmart HyperGate45 45mm wastegate
- KoyoRad half sized aluminum radiator
- Spal radiator fan wired for OEM connector / fan controller ( included )
- HKS radiator cap
- Vibrant silcone upper radiator hose
- Fuel Injector Clinic billet high flow fuel rail
- Aeromotive Fuel Pressure Regulator w/ gauge
Parts needed to run ( not included ) :
- Fuel injectors
- Coil on plug kit
- Speed density sensor
- MAP sensor
- Intercooler
Clean title in hand, willing to entertain reasonable offers. The only considered trades are HR 350z or 370z + at least 8k or well built drift set up. Read Less
The car is currently apart and does not run at as it is currently in need of the following parts listed below. The car is a clean title car with zero rust. I purchased this car in 2014 from southern California where it was originally owned. Since purchasing this car it has been garage kept and run very little ( a total of 4000 miles during my ownership ). In 2016 the engine was completely rebuilt featuring a 2.3 stroker and built/ported head. Since the rebuild the engine was run for roughly 1000 miles on a stock EVO 9 turbo before the car was taken down for the Sheepey components. The car does not include A/C components as they will not function with this forward facing turbo kit.
Good: Zero rust, clean interior ( aside from typical blue Recaro driver seat ), perfect dash , clean engine bay, no damage to core support or any major body components
Bad: Paint is in rough shape as clear coat is peeling on hood and roof. Various stratches around exterior, no major dents or damage just several average to light door dings. A vinyl wrap or paint would bring it back to life.
Engine 2.3 Stroker ( roughly 1000 miles at 420whp ) :
- Wiesco 1400HD Pistons 85.5mm 10.5:1
- Oliver Extreme Turbo Rods 150mm
- OEM 100mm crank shaft
- ARP Main Studs
- ARP L19 head studs
- ACL race bearing set
- All new OEM gaskets and seals everywhere
- New OEM oil pump & water pump
- New OEM EVO 9 timing belt with OEM pulleys and tensioner
- BSW street port and polished head
- GSC intake/exhaust valve set ( standard size )
- GSC Hi rev Beehive springs w/ titanium retainers
- GSC billet R2 Stroker cams 274
- Stock ported intake manifold
Transmission:
- All new gear sets including Evo 9 first gear
- Evo 9 carbon synchro's
- BSW custom shim spec
- All new seals and full refresh including paint
Installed aftermarket parts:
- ACT sprung 6 puck clutch w/ HD pressure plate
- Walbro 255 fuel pump
- Tein lowering springs ( stock struts )
- Torque Solutions short shifter w/ bushings
- Cobb shift knob
- Rexpeed carbon arm rest
- Rexpeed carbon gauge cluster trim
- Rexpeed carbon handbrake handle
- AEM wideband AFR gauge ( Digital )
- New OEM Evo 8 floor mats
Uninstalled Aftermarket parts:
- ( NEW ) Sheepey Race forward facing V-Band hot parts kit ( including teardrop hood dump down pipe and wastegate dump, full down pipe for optional catback use and 3 inch aluminum intercooler piping with couplers and T-Bolt clamps
- ( NEW ) Gen 2 Precision Turbo 6466 .82 V-Band
- Sheepey Race AN turbo feed and return lines ( with DEI heat shielding )
- ( NEW ) TurboSmart Race port 50mm BOV
- ( NEW ) TurboSmart HyperGate45 45mm wastegate
- KoyoRad half sized aluminum radiator
- Spal radiator fan wired for OEM connector / fan controller ( included )
- HKS radiator cap
- Vibrant silcone upper radiator hose
- Fuel Injector Clinic billet high flow fuel rail
- Aeromotive Fuel Pressure Regulator w/ gauge
Parts needed to run ( not included ) :
- Fuel injectors
- Coil on plug kit
- Speed density sensor
- MAP sensor
- Intercooler
Clean title in hand, willing to entertain reasonable offers. The only considered trades are HR 350z or 370z + at least 8k or well built drift set up. Read Less