Used 1981 Jeep CJ-7 (LS Swap) for sale in Broken Arrow, OK

1981 Jeep CJ-7 (LS Swap)

Hey everyone. The time has come, I am here to post my Jeep up for sale.

I have a 1981 CJ-7 Jeep Renegade (LS Swap) for sale. I originally bought this years ago. When I bought it, it was stock as could be. Since then, I have done plenty to it, way more than necessary by any means. This has been to Disney many a time and can go many more times. It has been heavily modified and is amazing for offroading and turning heads while driving through town. Full disclosure, since the LS Swap I have not had the time or motivation to rewire and setup the dash like I had been planning to do, so the gauges and dash is completely unhooked.

I am selling due to not having enough time to maintain, play, and work on it. As I said above, I have done plenty to it. Below you will find a breakdown of what I have installed and what all has been done to it.

Asking for $6,000 OBO. Not in a time crunch to sell. The Jeep runs great and has not had any issues with its current drivetrain, willing to setup a time for a test drive if you are interested.

Please let me know.

Thanks!

Details.
1981 CJ-7 tub and frome.
2005 Chevy 1500 5.3L V8
-5w-30 oil

1980 Chevy 1500 TH400 HD
-ATF Fluid
-32 Spline
-NP208/241 adapter

1990 (5) Chevy 1500 NP241
-ATF Fluid
-Super Short Slip Yoke Elimination Kit
-32 Spline

1990 Chevy S10 Tranny Mount

1979 Ford E-250 Dana 44F/60R

1991 Jeep YJ Steering Gear Box

1990 Jeep Cherokee Steering Column

300LPH Fuel Pump - BOSCH 0580254044

12,000lb Vortex WaterProof Winch

RCI 2021 "Racing" behind the seat fuel cell.

RCI 2021 fuel cell mount.
TLDR: LS Swap, TH400, NP241(SSSY), Dana44/60, Fuel cell, Custom cage,
stinger, and fenders.
I have also installed a full rollcage inside the Jeep that was built to also be in place with a hardtop (included) to go over it. The same individual that did the rollcage also did the custom front fenders for me as well as the stinger. Will work with the bikini top that I have for it as well. I have a set of doors that I was going to setup for my Jeep but have not gotten around to it. They just need some hinges, and they will be good to go. We have also stretched the rear end of the jeep ~10 inches and have a comp cut on the rear fenders. I was planning to get body armor to go over it to make it look a tad nicer, but never got around to that either. When doing the LS swap, we also had not gotten around to the gauges, so they are all disconnected and the factory gauges are gone. Was going to install some nice waterproof ones originally.
Please reach out for more questions, concerns,
inquiries, or to come see it or drive it.